Where is the ignition control module located on Chevy s10?

It’s contained within the PCM (Powertrain Control Module) located inside the left fender above he inner wheel well.

How do you test a Chevy ignition control module?

If your GM vehicle has a slow or hard start, the ignition control module should be tested with an electrical test light.

  1. Open the hood of the GM vehicle. Locate the ignition module.
  2. Connect the positive test light lead to the ignition module signal wire.
  3. Ask a partner to crank the engine numerous times.

What happens when the ignition switch on a Chevy S10 goes bad?

Your S10 stalls because the faulty switch turns off the fuel pump or power to the ignition. When this happens, the engine will not be able to run until it gets that signal back. 2. Starts then Dies If your Chevy S10 is starting right up, but then immediately dies, that is a very good indication that the ignition switch is bad.

What does the starter do on a Chevy S10?

This allows you to use the power windows, radio, and any other accessory that is equipped in your Chevy S10. Ignition- This position activates your ignition system and the fuel pump. At this point fuel is pressurized at the fuel rails, and the engine is ready to fire the plugs when it turns over. Starter- This position cranks the starter.

Can a bad ignition switch cause a car to stall?

Stalling on the Road The most noticeable symptom of a bad ignition switch is stalling. Your S10 stalls because the faulty switch turns off the fuel pump or power to the ignition. When this happens, the engine will not be able to run until it gets that signal back.

What are the symptoms of a bad ignition switch?

We’ve compiled some of the most common symptoms of a bad ignition switch . These include stalling issues, not starting, and no power to the radio or accessories. The S10’s ignition switch is not what your key goes into.

By FAQ